Yuba is a small household electrical appliance that incorporates bathroom heating, infra-red therapy, bathroom ventilation, daily lighting, and decorative functions through a smart combination of a special waterproof infrared light and ventilation fan. In the cold winter, the frequency of use is Very high, it takes a long time to repair or replace. It is also common. So how does the Yuba demolition it, what precautions do Yuba use? Here's to follow Xiaobian to understand it. 
How to remove the bathroom heater
1. First of all, remember to switch off all the switches of the bathroom heater and do not operate with electricity.
2. Find a ladder where the height is just enough to reach the lamp after standing up.
3. Turn the heating of the Yuba and the middle lights one by one.
4. After the lights are removed, the corners of the four headlights have a spring hook and care must be taken.
5. Remove the spring hooks on the four feet of the Yuba plastic cover in order.
6. Use a screwdriver to remove the screw that the bathroom heater is attached to the ceiling frame.
7. Remove Yuba's flue pipe and power cord, and the Yuba is removed. 
Yuba use precautions
1. The power distribution system should be standardized
Yuba power up to 1100W or more, so the power wiring installation Yuba must be a waterproof line, it is best not less than 1mm of multi-wire copper wire, all power wiring must take the plastic pipe inlaid in the wall, No open line settings are allowed.
2. The thickness of Yuba should not be too large
In the purchase of Yuba, it should be noted that do not choose a large amount of Yuba, usually around 20 cm is the best.
3. Should be installed in the center of the bathroom
Many family baths are installed directly above the bathtub or the location of the rain, so it seems to feel warm and warm, but this is actually a security risk. Because the infrared radiation lamp warms up quickly, it is easy to burn the skin of the human body if it is too close. The correct installation method should be installed in the center of the bathroom. 
4. Do not spray with water when working
In the bath, we must pay attention to, do not use water to spray shower tyrants, although many baths are now waterproof, but this will still have security risks,
5. Avoid frequent switching and vibration
Usually do not use the switch frequently Yuba, Yuba operation should not be surrounded by a larger vibration, otherwise it will affect the life of heating foam. If there is an abnormal situation during operation, it should be stopped immediately, and it must not be repaired and repaired on its own. It must be checked and repaired by the professional technicians of the after-sales service department.
6. Keep the bathroom clean and dry
After the end of the bath, do not turn off the bath immediately. Wait until the moisture in the bathroom is drained before shutting it off. In normal times, keep the bathroom ventilated, clean, and dry to prolong the service life of the bathroom heater. 
Editor's summary: The above is Xiaobian's introduction on how to disassemble Yuba and the precautions for using Yuba. After reading this article, everyone should have a certain understanding of how to disconnect and pay attention to Yuba . Yuba disassembly is actually quite complicated, so if you are not sure, you still have to consider professional masters to dismantle.
Chipboard Table Top,Particle Board Table Top,Furniture Table Top,Melamine Faced Chipboard Table Top
Changzhou Offistyle Furniture Co., Ltd. , https://www.offistylefurniture.com