Activated carbon plays a role in purifying water, and it takes a certain amount of time regardless of physical adsorption or chemical adsorption. Therefore, the water purifier manufacturer should improve the design of the activated carbon filter or activated carbon filter to increase the contact time of water and activated carbon as much as possible. Contact time = length of the carbon column / flow rate of water in the carbon column, increase the length of the carbon column and the amount of activated carbon By reducing the flow rate of water, the contact time between water and activated carbon can be prolonged, and the water purification effect and effluent quality of activated carbon can be improved.
Household activated carbon water purifier
In the urban construction industry standard CJ3023-1993 "activated carbon water purifier", no specific data such as contact time or water flow rate is given, but 5.2.1 stipulates that the ratio of the effective height to the diameter of the filter column of the activated carbon filter is 2~ 6 is appropriate, in fact, it is also to increase the height of the carbon column, extend the contact time of water and activated carbon, and prevent water from penetrating without contact with carbon. Some water purifiers use a multi-stage activated carbon filter, which is also the role. In short, the longer the contact time of activated carbon with water, the better the adsorption effect.
Large activated carbon water quality processor
In the mechanical industry standard JB/T2932-1999 "Technical Conditions for Water Treatment Equipment", the flow rate of water in the activated carbon filter should be ≤20m/h for the purpose of removing free chlorine, and the effluent water quality is residual chlorine<0.1mg/L. For the purpose of removing organic matter, the flow rate of water in the activated carbon filter should be ≤10m/h, and the effluent water quality is CODMn<2mgO2/L. In the pretreatment of large reverse osmosis unit, the residual chlorine and organic matter should be removed, and the flow rate is 10m/h. If the height of the activated carbon filter layer is 1m, the contact time between water and activated carbon is 0.1h, that is, 6 minutes.
Joint Wrapping Tape is a Cold Applied Tape coating system designed for the corrosion protection of field joints, fittings, and specialty piping. The unique adhesive retains conformability over a wide temperature range, yet exhibits an elevated level of shear resistance, which is a key in-ground performance characteristic. Coupled with a pliable, very malleable polyethylene backing, this versatile tape system can be applied by hand or with a wrapping machine.
Pipe Joint Wrapping Tape,Pipeline Repair Tape,Butyl Adhesive Tape,Bitumen Tape
Jining Qiangke Pipe Anticorrosion Materials CO.,Ltd , http://www.pipe-wrap-tape.com