| Home>Bearing knowledge>Opening of bearings |
Bearing disassembly
Source: Bearing network time: 2013-12-30
| /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
Pay attention not to operate the bearing and various parts; especially the dismantling of the interference cooperation bearing; it is very difficult to operate. Therefore, it is necessary to think about it beforehand in the drawing stage. It is also very important to manufacture and disassemble according to the requirements. According to the drawings, the method of dismantling, the order, and the cooperation conditions of the bearing are discussed; in order to obtain the full confidence of the opening operation.
1; disassemble the outer ring and disassemble the outer ring of the surplus fit; beforehand, place several outer ring kneading screw screws on the circumference of the outer casing; tighten the screw equally on one side; and disassemble one side. These screw holes are blindly closed. Plug; tapered roller bearing and other separate bearings; set a few cuts on the outer shoulder of the shell; use the block; use a press to open; or slam the open.
2; the opening of the inner ring of the cylindrical hole bearing; the most simple to pull out with the press. At this moment; pay attention to let the inner ring accept its pulling force. Need to think about the dimensions of the shaft shoulder; or discuss processing at the shoulder Up the ditch; in order to use the pick-up fixture.
The inner ring of the large bearing is disassembled and selected by the oil pressure method. The oil pressure is set on the shaft to make it easy to pull. The bearing with large width is used in combination with the drawing and clamping device;
The inner ring of NU type and NJ type cylindrical roller bearings can be disassembled by induction heating method. The part is heated in a short time; the inner ring is swollen and then pulled out. It is required to install a large number of such bearing inner rings; Use induction heating.
3; the taper hole bearing is disassembled and disassembled compared to the small sleeve bearing sleeve; the inner ring is supported by the block fastened on the shaft; the nut is turned back several times; the block is hit with the hammer to open and disassemble .
Large bearing; the use of no pressure to dismantle the year is more simple. In operation; there is the ability of the bearing to suddenly come out; it is best to use the nut as a block.
Recommend to friends comments close window
| Bearing related knowledge |
| Paper industry professional spherical roller bearing hardware common sense: the three major shortcomings of bearing steel metallurgy "active bearing" common sense professor replied: "Why is the bearing product rust?" "TIMKEN imported bearings protection protection" detailed |
This article links to http://
Please indicate China Bearing Network http://
Previous:The installation of FAG thrust bearing Next:Discussion on the classification of several common rolling bearings
Scissor and Knives are necessary for everyone's daily life. People love to use different functions of them for different works, our products line is including the chef knives, fruit knives, Kitchen Scissors and daily scissors. Reasonable choices not only meet the needs of the work, but also save people's time and improve work efficiency, quality and safe tools are especially important.
Scissor and Knives
Kitchen Knives,Multi Scissors,Daily Knives,Multi Household Scissors
Fortary Industry&Trading Co., Ltd. , https://www.fortary.com