A flush toilet is a necessary sanitary ware in our daily life. Whenever anything is used, a variety of problems will arise. The flush toilet is no exception. What should we do if there is a leak in the toilet ? Here we will study and learn together.
How to do toilet leaking:
First, the common cause of leaking water in toilets is that the hemispherical rubber cover of the cover drain is lighter. After the water tank is drained, the gravity is not enough. When the water tank is drained, it is not tight enough and it leaks. It is often necessary to repeatedly seal it. The solution is to tie a few heavy weights on the connecting rod that connects the rubber cover, such as large nuts, toothpaste, etc. Note that the binding should be as close to the rubber cover as possible, so that the rubber cover can be easily closed and the water leakage outlet is solved. .
Second, if the toilet in the home is leaking at the bottom, most of the time it is an installation problem. When it is not installed according to the strict installation requirements, it may lead to a leak in the toilet. The only way to solve this problem is to remove the toilet and reinstall it.
Third, if the toilet tank water leakage, then start from the drainage valve, if the water tank can be full, there overflow hole overflowing then the upper water valve is broken, if not enough water, but also drainage holes down, is Drain valve is broken, there are problems there for the other side.
Fourth, if the water tank is leaking, you can take down the water machine and clean up the scale. If it is still not enough, you need to change the toilet. Conditional households should change their water-saving sanitary appliances, and encourage everyone to install water-saving water appliances or sanitary ware, use ceramic chip-sealed faucets, eliminate spiral lift-type taps, and renovate toilet tanks over 9 liters. More than 6 liters of toilet tank. For existing non-water-saving flush toilets, try to reduce the amount of flush water by placing a brick or a salt water bottle inside the tank.
How to do a leak in a toilet leak
1, poor quality materials: some manufacturers blindly reduce production costs, use of inferior materials caused by the inlet valve inlet and inlet pipe itself cracking during injection molding, leading to sealing failure, the water in the tank overflow valve overflow pipe into the toilet, resulting in "long Flowing water."
2, excessive pursuit of miniaturization of water tank accessories, resulting in floating ball (or floating bucket) buoyancy is not enough, when the water submerged floating ball (or floating bucket), still can not make the inlet valve closed, so that water constantly flows into the tank, and finally Flow from the overflow pipe into the toilet caused leakage. This is especially true when the tap water pressure is high.
3. Improper design: The water tank fittings will cause interference when they move, resulting in water leakage. For example, when the water tank is filled with water, the float and the float rod will affect the normal reset of the flap and cause water leakage. In addition, the float rod is too long, and the float ball is too large, causing friction with the tank wall and affecting the free rise and fall of the float ball, resulting in seal failure and water leakage.
4, the drainage valve joints are not strict. The non-disposable drainage valve is not tightly sealed at the joint, and under the effect of water pressure, water flows from the gap between the interfaces into the toilet through the overflow pipe, causing water leakage. Elevated inlet valves that can be freely changed in height will often leak if their sealing rings do not fit tightly with the wall.
5. Check if the flush switch is reset. Some plastic flushing switches in toilets wear out for a long time and occasionally get stuck. Generally repeated switching a few times can be reset. Check whether the drain rubber gasket under the ball valve is aging, the seal is not strict, and the problem needs to be replaced.
The above is the related content of how to do the leaking of the toilet . I hope to help your home life. More exciting content is on this site. Stay tuned.
More articles:
When Philippine special bathroom recommended Philippine special bathroom
Shower room brand line shower room which brand is good
Wrigley bathroom cabinet recommended Wrigley bathroom cabinet please
Bath barrel what material bathroom products to buy
Toilet Home Furnishing Home
ASTM A554 Decorative Stainless Steel Pipes is the main tubing line for a piping system. Generally, ASTM A554 Decorative Stainless Steel Pipes are made in stainless steel 304 and 316L, but we provide other grade too such as hastelloy C22, 316Ti, Titanium and nickel alloy etc. Kaysen offer both Sanitary Seamless Tubes and Sanitary Welded Tubes to ASTM A270, ASTM A249, A269, ASTM A554, DIN11850, and size is up to 12″. Inner and outer surface is polished to meet the high purity requirement of hygienic industries. Kaysen is ability to supplying qualified ASTM A554 Decorative Stainless Steel Pipes comply to your your condition and FDA,GMP requirement.
ASTM A554 Decorative Stainless Steel Pipes - Polished Stainless Steel Tube – Stainless Steel Hygienic Tubes
Material: SS304, SS316L, EN 1.4301, EN 1.4404, etc
OD diameter: 1/2" - 12"
Thickness: 0.5mm - 6mm
Standard: ASTM, JIS, DIN, JIS, SUS, GB
Length: 6m or customer made
Tolerance: OD. ±0.2mm; Thickness: ±0.02mm; Length: ±0.5mm
Surface Treatment: Matt Finish or Mirror Finish (320# 400# 600#) etc
Application: Boiler, heat exchanger, construction, hygienic, pharmacy, power, petrochemical
Strength:
Heat Treatment of solution annealing for the sanitary tubings and fittings are available
High precision on dimension and wall thickness
Both seamless and welded sanitary tubings are available
Length is up to 12 meters.
Min. order quantity of sanitary tubings is from 300Kgs.
Offer industrial pipe and tubes according to order.
PMI test to verify material grade.
Visual and surface 100% examination before shipment.
End protected for shipment.
ASTM A554 Decorative Stainless Steel Pipes
ASTM A554 Decorative Stainless Steel Pipes,A554 Square Pipes,Stainless Steel Decorative Pipes
Kaysen Steel Industry Co., Ltd. , https://www.chinasanitaryvalve.com