No matter whether the style or the color of the floor is varied, many people still have a special liking for such a classic floor. Herringbone flooring can not only make the whole home more stylish, but also increase the sense of space. Today we have come to understand the installation of the herringbone floor and the buying skills. 
Herringbone floor installation
1. Make sure the floor is clean, dry, and flat before installation.
2. When installing the master, it is necessary to communicate with the owner. According to the owner's preference, choose the most suitable program.
3. Herringbone pattern: After cutting the right angle at 45 degrees, install the first floor and assemble the groove with a small groove at the opposite end of the groove.
4. Beat the floor with a clapper and a hammer and put together the floor to avoid gaps.
5. After the floor has been installed, remove the temporarily used wooden beams, ensure that there are expansion joints, and install the skirting board. The underside of the skirting board is tightly integrated with the floor surface. 
6. Lay the floor on the keel designed with geothermal heat pipe. The straight scab on the floor must be laid on the keel. The width of the keel shall not be less than 45mm. The interval between the center of each keel shall not be greater than 300mm.
7. The installation quality of the floor, in line with the principle of who is responsible for who is responsible for installation, the construction teams are required to strictly comply with the construction procedures established by the company and the country's regulations for wood floor installation to ensure project quality.
Herringbone floor selection skills
1. Look at the water resistance of the floor
Water resistance is very important. If it is a floor with poor water resistance, it will cause the floor to swell and other undesirable phenomena.
2. Flame retardancy
Because the flame retardant properties of wooden floors cannot be too high, a simple test method can be used to place the cigarettes on the floor surface. After the burning is completed, the floor is not burnt and the marks cannot be removed, such as no cracks, dark spots and blisters. Said qualified flame-retardant performance.
3. Gluing
Solid wood flooring is made of natural wood and is not treated with any adhesive. Solid wood composite flooring is made of hot-pressed adhesive coated board surface, so the adhesive performance is an important quality indicator of the product and will directly affect the product's function and life. 
4. Formaldehyde content
Solid wood composite flooring and laminate flooring contain a certain amount of formaldehyde in the adhesive. It will gradually release to the surrounding environment in gaseous form.
5. Wear resistance
The laminate flooring has good wear resistance because it has a wear layer on its surface.
6. Paint finish
The surface of solid wood floor and engineered wood floor is painted and painted. When selecting, check that the paint surface is uniform, smooth and smooth.
7. Floor hardness
The greater the density of the laminate flooring substrate, the higher the mechanical properties and impact resistance, and therefore the side is more resistant to knocking, but the larger the density, the better. 
Editor's summary: The above is the introduction of Xiaobian 's herringbone floor installation method and herringbone flooring 's purchase skills. After reading this article, did everyone understand more about the herringbone parquet flooring ? In fact, quality and environmental protection are the most important.
G70 Rigging Hardware,G43 Rigging Hardware,G70 Lifting Hardware,G70&G43 Rigging Equipment
Shandong Shenli Rigging Co.,LTD. , https://www.shenliriggingcn.com